[Label Size]
222
Bottom I-Mark
Select when the I-mark is positioned at the bottom.
(1) Media feed direction
Top I-Mark
Select when the I-mark is positioned at the top.
(1) Media feed direction
Custom I-Mark
Custom I-mark allows using labels where the I-mark position does not correspond with [Center I-
Mark], [Bottom I-Mark] and [Top I-Mark]. With the [I-Mark Offset] setting, you can set the position
of the I-mark. The stop position and the printed image will be adjusted accordingly but the
backfeed distance will not change.
This I-mark position is an example.
(1) Media feed direction
• If you have selected [Cutter], [Partial cutter], [Linerless cutter] or [Linerless tearoff] in
the [Print Mode] menu, [Center I-Mark] is not available.
[Label Size]
Set the label size to determine the position of the center I-mark.
To Next Page
Loading...
