SATO FX3-LX - [I-Mark Offset]

223
Appears only if you have selected [Center I-Mark] in the [I-Mark Position] menu.
The options are as follows:
• [16mm]
• [20mm]
• [25mm]
• [35mm]
• [38mm]
(1) Media feed direction
(2) Print position
(3) I-mark position
(4) Label size
The center I-mark position (3) is determined by the label size (4).
Label size (4) I-mark Position (3)
16.0 mm 4.7 mm
20.3 mm 7.0 mm
25.4 mm 13.0 mm
35.0 mm -3.0 mm (rear label end)
38.1 mm 9.0 mm
[I-Mark Offset]
Set the I-mark offset position.
Appears only if you have selected [Custom I-Mark] in the [I-Mark Position] menu.