SATO FX3-LX - [Sensor Type]; [I-Mark Position]

221
[Sensor Type]
Set the sensor type for detecting the media.
The options are as follows:
None
Disable the media sensor.
Gap
Select when using the media of Gap type. Use the transmissive type sensor.
I-Mark
Select when using the media of I-mark type. Use the reflective type sensor.
• If [Dispenser] is selected in the [Print Mode] menu, only [Gap] and [I-Mark] will be
available.
• If you have selected [Linerless tearoff] or [Linerless cutter] in the [Print Mode] menu,
only [None] and [I-Mark] will be available.
[I-Mark Position]
Set the position of the I-mark.
Appears only if you have selected [I-Mark] in the [Sensor Type] menu.
The options are as follows:
Center I-Mark
Select when the I-mark is positioned at the center.
The I-mark position is determined by the label size.
(1) Media feed direction