SATO FX3-LX - [Tools] Menu

[Tools] Menu
410
[Tools] Menu
The initial value refers to the setting value of the printer when it was shipped from the factory. The
table below shows the initial value of each setting item.
Setting Item Initial Value
[Test Print]
[Factory]
[Label Width] Large
[Pitch] 0 dot
[Offset] 0 dot
[Darkness Adjust] 50
[Configure List]
[Category] All
[Label Width] Small
[Label Length] 660 dots
[Pitch] 0 dot
[Offset] 0 dot
[Darkness Adjust] 50
[Configure QR]
[Category] All
[Label Width] Small
[Label Length] 660 dots
[Pitch] 0 dot
[Offset] 0 dot
[Darkness Adjust] 50
[Paper Sensor]
[Label Width] Small
[Label Length] 660 dots
[Pitch] 0 dot