SATO FX3-LX - Loading the Media Roll (Printing in Cutter Mode;Partial Cutter Mode)

Loading the Media Roll (Printing in Cutter Mode/Partial Cutter Mode)
200
10. Tap [FEED].
The media is fed to the print start position.
Loading the Media Roll (Printing in Cutter Mode/Partial Cutter Mode)
• The print head and its surroundings are hot after printing. Be careful not to touch it, to
avoid being burned. Do not replace the media immediately after printing.
• Touching the edge of the print head with your bare hand could cause injury.
• Be careful not to touch the cutter blade.
• Adjust the cut position so as not to cut the label.
• To print in cutter mode, the optional cutter kit is necessary.
• To print in partial cutter mode, the optional partial cutter kit is necessary.