29
Limitation of Liability
• SATO Corporation and its subsidiaries in Japan, the U.S. and other countries make no
representations or warranties of any kind regarding this material, including, but not limited to,
implied warranties of merchantability and fitness for a particular purpose. SATO Corporation shall
not be held responsible for errors contained herein or any omissions from this material or for any
damages, whether direct, indirect, incidental or consequential, in connection with the furnishing,
distribution, performance or use of this material.
• Specifications and contents in this document are subject to change without notice.
• Be sure to perform a virus check for the USB memory before connecting it to the printer. SATO
Corporation shall not be held responsible for any printer malfunctions caused by a virus spread
via USB memory.
• This printer (excluding options and bundled accessories) conforms to the waterproof performance
of IPX2 (splash-proof II type).
However, it does not exhibit waterproof performance in the following conditions:
◦ Flow rate or running water angle exceeding IPX2
◦ Opening or closing the top cover while the exterior of the printer is wet
◦ While the top cover is open
◦ While the dispenser cover is open
◦ While the interface covers are open
◦ While the AC adapter is disconnected and the DC cover is open
◦ When covers are damaged or deformed
◦ While using the wall mount kit
◦ While using the fan-fold media
◦ When wet media is used
◦ When the printer is in water deeper than 10 mm (0.39”)
• Various types of data registered in the printer and applications may be damaged. We recommend
saving data separately in advance.
To Next Page
Loading...
