SATO FX3-LX - Using the Optional Cradle Kit

Using the Optional Cradle Kit
104
1. Remove the terminal protection seal (2) on the bottom of the battery mount kit (1).
You can now see the charging terminal (3).
• Do not touch the charging terminal with wet hands.
• If the charging terminal is dirty, clean the dirt using a dry cloth or a cotton swab.
• Do not remove the terminal protection seal on the bottom of the battery mount kit if you
will not be using the optional cradle kit.
2. Mount the printer with the battery mount kit (5) on the cradle kit (4).
Using the Optional Cradle Kit
Storing the AC Adapter in the Cradle Kit
• Do not connect or disconnect the power cord while your hands are wet. Doing so could
cause an electric shock.