225
Dispenser
Peels the liner from the printed label as the label is fed to the printer’s front. Once the printed label
has been removed from the printer for application, the next label retracts and positions itself for
printing.
Cutter
Cuts each media while printing the specified number of media. You can specify this option only if
you have installed the cutter kit.
Linerless cutter
Prints and cuts each media. After the cut media is removed, the next media retracts and positions
itself for printing. You can specify this option only if you have installed the cutter kit. When using a
linerless label, install the optional linerless kit and select [Linerless cutter] instead of [Cutter].
Partial cutter
Cuts each media leaving a part of the media while printing the specified number of media. You
can specify this option only if you have installed the partial cutter kit.
• The selectable print modes differ in accordance with the installed option.
• You cannot set the [Print Mode] if [Auto-mode] is enabled.
[Backfeed]
[Backfeed] is applicable only when the print mode is set to something other than continuous mode.
The options are as follows:
None
Does not backfeed.
After
After cut, backfeed the front part of the next media to the print head position. For dispenser mode,
backfeed the front part of the next label after dispensing the label.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
