[SZPL]
268
[Kanji Command]
Set the printer behavior when the received data includes the Kanji command ESC+K5, ESC+K6 or
ESC+K7.
Change the Kanji commands ESC+K5, ESC+K6 and ESC+K7 in the received data to the proper
commands and print.
◦ ESC+K5: 16x16 dots Kanji in horizontal line with one-byte character
◦ ESC+K6: 24x24 dots Kanji in horizontal line with one-byte character
◦ ESC+K7: 22x22 dots Kanji in horizontal line
Do not change the Kanji commands ESC+K5, ESC+K6 and ESC+K7 in the received data. The
printer behavior when it receives these commands is as follows:
◦ ESC+K5: Print with 40x40 dots Kanji in horizontal line.
◦ ESC+K6: A command error occurs and the data will not be printed.
◦ ESC+K7: A command error occurs and the data will not be printed.
[Call Font/Logo]
Set how to process the character code specified in Recall font & logo command (ESC+RF).
Character codes are processed in little-endian format.
Character codes are processed in big-endian format.
[SZPL]
To use SZPL as a printer command, set the following items:
[Label]
Set the print position.
The setting items are as follows:
[Shift]
Set the shift offset position of the label.
The setting range is from -960 to +960 dots.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
