SATO FX3-LX - Page 245

245
Status5
Mode Data format
Normal
([Legacy
Status for
Port 9100]
is disabled)
Legacy
status
([Legacy
Status for
Port 9100]
is enabled)
[BCC] (USB+LAN Model Only)
Enable or disable the BCC check function.
Appears only if you have selected [STATUS5] in the [Flow Control] menu.
[Delay Reply ENQ] (USB+LAN Model Only)
Set the period to delay status reply to status request ENQ.
Available only if you have selected [STATUS3], [STATUS4 ENQ], [STATUS5], or [NONE] in the [Flow
Control] menu.
The setting range is from 0 to 9999 ms.
• Normally, keep this setting at the initial value.
[Status4 Cyclic Response] (USB+LAN Model Only)
Set the interval for the cyclic status response.
Available only if you have selected [STATUS4] in the [Flow Control] menu.
The setting range is from 100 to 999 ms.
[Proxy (LAN)] (USB+LAN Model Only)
Set the proxy for the LAN.
The setting items are as follows:
[Enabled] (USB+LAN Model Only)
Enable or disable use of proxy.
• To enable the proxy, [Server] should be set and [Exclude] must contain at least
127.0.0.1 and localhost.