[SEPL]
278
The setting range is from 0 to 400 dots.
• The length of 1 dot is 0.083 mm (0.0033").
• You can change the unit to dots or inches in the [System] > [Regional] > [Unit] menu.
[Memory Device]
Select the printer's memory space in which to store forms, graphics and fonts.
The options are as follows:
Internal RAM
Use the printer's RAM. The data will be lost if the printer is powered off.
Internal FLASH
Use the printer's flash memory.
USB1
Use the upper USB connector on the back of the printer.
USB2
Use the lower USB connector on the back of the printer.
USB3
Use the internal USB connector.
• Be sure to perform a virus check on the USB memory before connecting it to the
printer. SATO Corporation shall not be held responsible for any printer malfunctions
caused by a virus spread via USB memory.
[Sim. 300 DPI Head]
Enable or disable 300 dpi simulation mode.
Enable 300 dpi simulation mode. The sizes and positions of objects such as lines, boxes and
barcodes in the print data are automatically adjusted to the equivalent 300 dpi sizes and positions
for printing.
Disable 300 dpi simulation mode.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
