[Wi-Fi Setting]
320
[Netmask]
Set and check the subnet mask address.
If you have selected [DHCP] in the [Mode] menu, the screen shows the subnet mask address you
received from the DHCP server.
If you have selected [Static] in the [Mode] menu, set the subnet mask address.
Each group of the address can be set among 0, 128, 192, 224, 240, 248, 252, 254 and 255.
The setting range is as follows:
128.000.000.000 to 255.255.255.254
[Gateway]
Set and check the default gateway address.
If you have selected [DHCP] in the [Mode] menu, the screen shows the gateway address you received
from the DHCP server.
If you have selected [Static] in the [Mode] menu, set the default gateway address.
The setting range is as follows:
000.000.000.000 to 255.255.255.255
• The gateway address set here is shared with the settings in [Interface] > [Network] >
[Settings] > [LAN] > [IPv4 (LAN)].
[DNS]
If you have selected [Static] in the [Mode] menu, set and check DNS server addresses.
The setting range is as follows:
000.000.000.000 to 255.255.255.255
•
You can register up to three IP addresses for the DNS server. Tap to add different
IP addresses.
• The DNS server addresses set here are shared with the settings in [Interface] >
[Network] > [Settings] > [LAN] > [IPv4 (LAN)].
[IPv6 (Wi-Fi)]
Configure IPv6 for Wi-Fi.
•
After doing the settings, tap or press the / (Standby/Home) button. A
message asking you whether to save the settings appears. Tap on the message to
enable the new settings. Tap to cancel the new settings and return to the previous
settings.
• If there are any errors with the input information, a message asking you whether to
discard changes appears. Tap on the message to discard the changes. Tap to
close the dialog.
To Next Page
Loading...
