SATO S84NX - Page 525

525
Error Message 1123 (Write Tag Error) (S84NX Only)
When there is an error with the product, the error message appears on the screen.
Check the cause and countermeasure, and then take appropriate action.
To clear the error:
Press the button (RETRY), and then execute the retry/release operation set in [Retry Mode],
or press the button (ABORT).
Retry Mode
To cancel an entire print job, open and close the top cover to switch the product to Offline mode, and
then press the button (CANCEL).
Cause and Countermeasure Reference
Cause (1)
Tried to write to an inlay that was write-locked.
Countermeasure (1)
Use tags that are not locked.
-
Cause (2)
Tried to write to an inlay when the writing power is low.
Countermeasure (2)
Adjust [Write Power]/[Read Power].
Write Power
Read Power
Contact your SATO technical support if the error cannot be resolved.
Contact Information for When You Are in Trouble
• You cannot use an RFID tag that has caused an RFID tag error. An error message is
printed on the RFID tag that caused the error.