SATO S84NX - Page 526

526
Error Message 1126 (Not Enough Power) (S84NX Only)
When there is an error with the product, the error message appears on the screen.
Check the cause and countermeasure, and then take appropriate action.
To clear the error:
Press the button (RETRY), and then execute the retry/release operation set in [Retry Mode],
or press the button (ABORT).
Retry Mode
To cancel an entire print job, open and close the top cover to switch the product to Offline mode, and
then press the button (CANCEL).
Cause and Countermeasure Reference
Cause
The [RSSI Filter] function is enabled, and the RSSI
value of the inlay is lower than the values set in
[Threshold Value].
Countermeasure
◦ Check the tags. Or, check the [Threshold Value]
settings.
◦ Adjust [Write Power]/[Read Power].
Threshold Value
Write Power
Read Power
Contact your SATO technical support if the error cannot be resolved.
Contact Information for When You Are in Trouble
• You cannot use an RFID tag that has caused an RFID tag error. An error message is
printed on the RFID tag that caused the error.