12 - 7
STEERING SYSTEM
B
B
A
B
BEARING REPLACEMENT
【A】Steering column
【B】Steering
◆ Clamp the steering column【A】with a vise, use a
suitable crowbar to go deep into the steering column,
and knock out the bearings【B】at both ends;
◆ Using a bearing driver, press the bearings【B】at
both ends into the steering column on the pressure
equipment【B】
!
Before installing the bearing, make sure that the bearing
is intact without scratches and corrosion. The bearing
and the hole are cleaned and free of impurities. The
bearing can be fl exibly rotated by hand after pressing.
To Next Page
Loading...
