Engineering via SICAM WEB
SICAM A8000 / CP-8000 • CP-8021 • CP-8022 Manual Unrestricted 357
DC8-037-2.02, Edition 10.2017
Example: Process data message
• Under the tab Parameter, select the category “Process data message”
All signals assigned to that category are displayed.
• Enter for each signal the desired texts for name and states
• Select for each signal, whether it is to be logged as an event
• Select for each signal, whether it is to be logged as an alarm
• Select for each signal, whether it is to be logged in the process data archive
• For the process display in the cockpit, assign the desired group number and the position
within the group
In this example, 3 binary information items are assigned to the group positions 1, 3 and 4.
When position 2 is not used, at this place an empty line will be displayed on the LCD (see
11.1.2.4.5, Cockpit).
Description of the parameters see Process data message.
To Next Page
Loading...
