Siemens HydroRanger 200 HMI - Page 380

LCD menu structure
H.1 LCD Menu Structure
HydroRanger 200 HMI
378 Operating Instructions, 06/2018, A5E36281317-AC
2.8.2. MODIFIERS (Page 200)
2.8.2.1. RELAY SELECTOR
(Page 201)
2.8.2.2. PUMP GROUP
(Page 201)
2.8.2.3. RELAY FAIL
-SAFE (Page 201)
2.8.2.4. RELAY INTERVAL SETPOINT
(Page 202)
2.8.2.5. RELAY DEAD BAND
(Page 203)
2.8.2.6. WALL CLING REDUCTION (Page 204)
2.8.2.6.1. TRANSDUCER SELECTOR
(Page 204)
2.8.2.6.2. LEVEL SETPOINT VARIATION (Page 204)
2.8.2.7. PUMP RUN-ON (Page 205)
2.8.2.7.1. RUN
-ON INTERVAL (Page 205)
2.
8.2.7.2. RELAY SELECTOR (Page 205)
2.8.2.7.3. RUN-ON DURATION (Page 206)
2.8.2.8. PUMP START DELAYS (Page 206)
2.8.2.8.1. DELAY BETWEEN STARTS
(Page 207)
2.8.2.8.2. POWER RESUMPTION DELAY (Page 207)
2.9. DISCRETE INPUTS (Page 207)
2.9.1. BACKUP LEVEL OVERRIDE (Page 207)
2.9.1.1. TRANSDUCER SELECTOR
(Page 208)
2.9.1.2. DISCRETE INPUT NUMBER
(Page 208)
2.9.1.3. LEVEL OVERRIDE VALUE
(Page 208)
2.9.1.4. OVERRIDE TIME DELAY (Page 209)
2.9.2. DISCRETE INPUT LOGIC (Page 209)
2.9.2.1. DISCRETE INPUT 1
(Page 209)
2.9.2.2. DISCRETE INPUT 2
(Page 209)
2.9.2.3. DISCRETE INPUT 1 SCALED STATE
(Page 210)
3.3.1.4. DISCRETE INPUT 2 SCALED STATE (Page 210)
2.10. OTHER CONTROL (Page 210)
2.10.1. EXTERNAL TOTALIZER (Page 210)
2.10.1.1. TRANSDUCER SELECTOR
(Page 210)
2.10.1.2. MULTIPLIER
(Page 211)
2.10.1.3. RELAY DURATION (Page 211)
2.10.2. EXTERNAL SAMPLER (Page 212)
2.10.2
.1. TRANSDUCER SELECTOR (Page 212)
2.10.2.2. MANTISSA
(Page 213)
2.10.2.3. EXPONENT
(Page 214)
2.10.2.4. RELAY DURATION
(Page 215)
2.10.2.5. RELAY SELECTOR
(Page 215)
2.10.2.6. RELAY INTERVAL SETPOINT (Page 215)