Siemens optiPoint 410 entry User Manual

Alphabetical Reference
204
Mobility International ID
If this function is activated, the Mobility ID entered is completed using val-
ues from the Dialing Properties Table for the registration. This is only done
if the ID entered does not exceed 6 digits. See also ! page 181
! page 101 ! page 134
Originating line preference
Originating Line selection – provides connection of the phone to one of the
lines appearing on it, on an automatic basis when the user goes off-hook
or starts on-hook dialing. There are four originating options.
A Keyset is assigned one of the following preferences.
• Prime Line Preference – The designated Prime Line is always select-
ed for originating calls.
• Idle Line Preference – Any idle line is selected for originating calls with
the lines selected based on line selection table for the device (e.g.,
prime line first). See also line rank on ! page 199 and Terminating line
preference on ! page 223.
• Last Line Preference – The line selected for originating calls is the line
selected for the last call (originating or terminating).
• No (Originating) Line Preference – A line key must be pre-selected
or post-selected each time the user goes off-hook.
Select the according line preference:
– Idle line
– Primary
–Last
– None
! page 68 ! page 123

Siemens optiPoint 410 entry Specifications

General

Brand	Siemens
Model	optiPoint 410 entry
Category	Telephone
Language	English