Alphabetical Reference
226
VLAN discovery method
• Can be defined only if the ! Layer 2 support is activated (! Quality of
Service (QoS)).
• Use this function to define the location from where the ! Manual
VLAN identifier should be fetched, if ! VLAN is used.
! page 59 ! page 117
Voicemail number
• The number of where your voice mail server is located.
• Value range table:
• Editing by phone: Number Editor ! page 157.
! page 65 ! page 115
WAP Connection Type/mode
• Choose the protocol over which the data transfer should take place for
! WAP applications: ! HTTP or ! WSP.
! page 80 ! page 137
WAP proxy Password
Allows the user password on the WAP server to be changed.
. ! page 80 ! page 137
WAP Server Address
•If a ! WAP server exists, enter the ! IP address of this server here.
• Standard address ! page 241.
• IP editor in optiPoint 410/420 ! page 159.
! page 80 ! page 137
Manual The ID entered in ! Manual VLAN identifier is used.
DHCP If a ! DHCP server is used, then the ID delivered by
this server is applied.
Permitted values numeric
Length max. 20 digits
To Next Page
Loading...
