Extended Administration
97
Restore Factory Settings
optiPoint 410/420 S V6.0 display phones
The following procedure can be invoked in order to reset the optiPoint 410/
420 /economy/economy plus/standard/advance back to its default factory
settings.
To perform a factory reset:
• Remove the LAN connection ()! page 20.
• Take the handset off hook.
• Make sure the phone is in idle state ("No network" is flashing).
• Press the following keys in a row:
vuq g.
• Enter reset password: "124816".
• Press the key
: .
• Reconnect the LAN connection ! page 20.
• Replace the handset.
You also can use the Web Interface to reset factory settings ! page 145.
After reset you will be prompted for the terminal number. Enter the re-
quested terminal number. If you do not enter a valid number within a pre-
defined time, the IP number of the phone appears on the display. You can
enter the number later, using the phone menu or the Web Interface. If you
use the "downloaded configuration", the number will be inserted automat-
ically.
optiPoint 410 entry
To perform a factory reset:
• Remove the LAN connection ! page 20.
• Press hard keys '2', '8' and '9' simultaneously,
• Press the '*' hard key
• Enter the standard factory reset password "124816",
• Terminate by pressing the '#' hard key.
You also can use the Web Interface to reset factory settings ! page 145
7
Attention
A factory reset deletes all administration data, passwords (except
reset password) and user configurations. IP and SIP connections will
be lost.
To avoid the necessity of re-entering the phone configuration manu-
ally after restoring factory settings use the Upload Configuration
function ! page 75 to save the configuration. After factory reset the
FTP password is replaced with the string "123abc".
When Power over LAN do not disconnect the LAN.
When Power over LAN do not disconnect the LAN.
To Next Page
Loading...
Need help?
General