Siemens optiPoint 410 entry User Manual

Step by Step
Basic Administration
54
Manual Configuration
If your network does not use a DHCP server, you must
disable the DHCP IP assignment manually and specify
the phone’s IP address and subnet mask and the net-
work gateway IP address (default route) for the phone.
Entering the administration area
e d g Press the keys simultaneously
or
v u q j Press the keys successively.
o Enter admin password
(default: 123456).
r Terminate the operation.
You are now in the Administration Area (all LEDs
flash).
The top two function keys take over the following func-
tions in this area:
1
st
Function key
Press 1
st
function key to make settings.
2
nd
Function key
Press 2
nd
function key to view settings. (ASCII results
codes see ! Seite 160)
Configure basics
Press 1
st
function key.
dd Enter code
d Switch the DHCP IP assign off.
r Terminate the operation.
Press 1
st
function key.
de Enter code.
o Enter IP address of the optiPoint 410 entry
(to edit see ! Seite 160).
r Terminate the operation.
Press 1
st
function key.
<PROG>
<VIEW>
<PROG>
<PROG>
<PROG>

Siemens optiPoint 410 entry Specifications

General

Brand	Siemens
Model	optiPoint 410 entry
Category	Telephone
Language	English