Siemens SIMATIC ET 200pro - Page 14

SIMATIC – ET 200pro motor starter
xii GWA 4NEB 950 5661-02 DS 04
Figure 8-14: Load and motor torque as well as motor terminal voltage
for operation at the soft starter . . . . . . . . . . . . . . . . . . . . . 8-37
Figure 8-15: Reduction depending on the installation height . . . . . . . . . . . . 8-38
Figure 9-1: Example: Power infeed . . . . . . . . . . . . . . . . . . . . . . . . . 9-3
Figure 9-2: Example: power infeed with turned socket insert . . . . . . . . . . . 9-4
Figure 9-3: Example: power relaying . . . . . . . . . . . . . . . . . . . . . . . . 9-4
Figure 9-4: Example: motor connection cable . . . . . . . . . . . . . . . . . . . 9-5
Figure 9-5: Plug connector for special modules RSM and F-RSM . . . . . . . . . 9-6
Figure 9-6: Plug connector for motor starter . . . . . . . . . . . . . . . . . . . . 9-7
Figure 10-1: Device functional principle . . . . . . . . . . . . . . . . . . . . . . . 10-1
Figure 10-2:Tripping classes . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10-6
Figure 10-3: Cooling down characteristics with and without idle time . . . . . . . 10-8
Figure 10-4: Principle of blocking protection . . . . . . . . . . . . . . . . . . . . . 10-13
Figure 10-5: Principle of soft start-up / soft run-down . . . . . . . . . . . . . . . . 10-26
Figure 10-6: Example of a circuit for mechanical braking . . . . . . . . . . . . . . 10-30
Figure 10-7:Local device interface . . . . . . . . . . . . . . . . . . . . . . . . . 10-40
Figure 10-8: Data channels . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10-41
Figure C-1: Configuration with maintenance isolating module and
ECOFAST connection . . . . . . . . . . . . . . . . . . . . . . . . . C-2
Figure C-2: Configuration without maintenance isolating module . . . . . . . . . C-4
Figure C-3: Configuration for hot swapping . . . . . . . . . . . . . . . . . . . . . C-6
Figure C-4: Configuration with EMERGENCY STOP,
1-channel with monitored START . . . . . . . . . . . . . . . . . . . C-8
Figure C-5: Configuration with EMERGENCY STOP,
2-channel with monitored START . . . . . . . . . . . . . . . . . . . C-10
Figure C-6: Configuration for safety door monitoring, 1-channel,
and automatic restart . . . . . . . . . . . . . . . . . . . . . . . . . . C-12
Figure D-1: Current formats . . . . . . . . . . . . . . . . . . . . . . . . . . . . . D-1
Figure D-2: Byte arrangements in the format 'big endian' . . . . . . . . . . . . . D-5