Data formats and data records
SIMATIC – ET 200pro motor starter
GWA 4NEB 950 5661-02 DS 04
D-31
D.4 Device parameters
If the DP V1 functions are used, complete data records can be interchanged
with the starters across the ET 200pro rear-wall bus. The telegram traffic
between the interface module and the special modules or motor starters takes
place in blocks of up to 16 bytes in length. In each case, the complete block of a
data record must be transferred.
For extended parameterization of the ET 200pro starters, the following ele-
ments of data record 131 (1st block / 62 bytes) are used:
ET 200
pro
RPM
Byte
No.
DS 131
Byte no.
Parameters Value range
Increme
nt
Factory
setting
Relevant for
0…3 NST2000 header In accordance with system specification
4…7 Device functions 2 Content device-specific
8…11 Device functions 1 Not accessible via DP V1
12…13 Rated operating cur-
rent
Not used
1
0…7
and
2
0…7
14
0…7
and
15
0…7
Rated operating cur-
rent I
e
A
0.15…2 A 10 mA 0.15 / 2.0 all starters
Rated operating cur-
rent I
e
A
1.5...12 A 10 mA 1.5 / 12
16
0
Load type 3-phase motor [0]
1-phase motor [1]
[0]
DSe, RSe
(ST and HF)
16
1
Protection against
voltage failure
yes [1]
no [0]
[1] all starters
16
2…7
Reserved —
17
0…7
Pre-warning limit
value,
motor heating
0…95%;
deactivated [0]
5% 0%
DSe, RSe (HF);
sDSSte/sDSte,
sRSSte/sRSte
6
4…5
18
0…1
Response to over-
load – thermal motor
model
Tripping without
restart [0]
Tripping with restart
[1]
Warning [2]
—[0]
DSe, RSe (HF);
sDSSte/sDSte,
sRSSte/sRSte
18
2…7
Reserved —
6
0…3
19
0…3
Tripping class CLASS 5 [3]
CLASS 10 [0]
CLASS 15 [4]
CLASS 20 [1]
—[0]
DSe, RSe (HF);
sDSSte/sDSte,
sRSSte/sRSte
19
4…7
Reserved —
Table D-18: Data record 131 – device parameters
To Next Page
Loading...
