ITC Operating mode
5.5 Assigning device parameters
ITC V3, ITC V3 PRO
104 Operating Instructions, 03/2024, A5E42761061-AF
4. Repeat the new password.
5. If you select "Hide passwords", the password is no longer shown when you log on.
Forgetting the administrator password
If you forget your administrator password, you must restore the factory settings.
Losing the current configuration settings
When restoring to factory settings, the current configuration file is overwritten.
After factory settings are restored, a saved configuration file can be transferred back to the
device.
Once the configuration file is restored, the password contained therein will be valid after the
device is restarted. Change the password if necessary, and make a note of it.
Closing connections with connection password
You can specify a password for terminating a client-server connection in the Start menu
"Configuration > Passwords". If the operator wants to terminate a connection, this connection
password must be entered. If the operator enters an incorrect password, the connection will
not be terminated.
No connection password is assigned in the factory state. Without password protection it is
possible for unauthorized persons to terminate client
-server connections.
Following initial commissioning and after restoring the factory settings, you should
immediately assign a connection password.
Closing Citrix and connection password
When an operator closes a Citrix application program via the user menu or closes the
Windows window, Citrix is also terminated without entering the connection password.
The length of the connection password is restricted to a maximum of 30 characters.
If a connection password has been specified, you can alternatively terminate a client
-server
connection by using the administrator password.
If you select "Allow restart", the menu entry "Restart" will be displayed underneath in the Start
menu. The operator can use this entry to restart the device.
To Next Page
Loading...
