Siemens SIMATIC ITC1200 V3 - ITC Operating Mode; System Requirements

ITC V3, ITC V3 PRO
Operating Instructions, 03/2024, A5E42761061-AF
77
ITC Operating mode
5
5.1 System requirements
The following list shows the operating system and software requirements depending on the
specific connection type.
• RDP, Sm@rtServer
RDP
Sm@rtServer
X
Windows Server 2008 R2 (64-bit)
X
Windows Server 2012 R2 (64-bit)
X
Windows Server 2016 (64-bit)
X
Windows Server 2019 (64-bit)
X
Microsoft Windows 7 SP1 (32-bit and 64-bit)
X
Microsoft Windows 10 (32-bit and 64-bit)
X
Microsoft Windows 11 (64 Bit)
X
As of SIMATIC WinCC V14 (TIA Portal) with the options:
• SIMATIC WinCC Sm@rtServer for SIMATIC Panels
• SIMATIC WinCC Sm@rtServer for Runtime Advanced
• VNC: The following protocols are supported for the following versions:
RealVNC 6.0.1, TightVNC 2.8.5 and UltraVNC 1.2.1.0
• WinCC OA: The connection to WinCC OA is supported as of version WinCC OA 3.16.
Support with an earlier version can be requested from the WinCC OA team. Additional
information can be found on the Internet at the following address:
SIMATIC WinCC Open Architecture
(https://new.siemens.com/global/en/products/automation/industry-software/automation-
software/scada/simatic-wincc-oa/wincc-oa-basic-software.html)
• Citrix: The current Citrix version is supported. The corresponding system requirements
apply. Additional information can be found on the Internet at the following address:
Citrix product page (https://www.citrix.com/products.html)
• Web access via HTML5
See also
Technical support (https://support.industry.siemens.com)