Safety instructions
2.1 General safety instructions
ITC V3, ITC V3 PRO
36 Operating Instructions, 03/2024, A5E42761061-AF
Safety instructions for PRO devices
The device must be mounted on a suitable support arm or pedestal
If the device is not mounted, mounted improperly or mounted on an unsuitable support arm
system or pedestal system, liquids, dust or gases can enter the device. This can result in
malfunctions which could cause death or serious injuries.
The device is only considered enclosed equipment and only fulfils the specified degree of
protection or Enclosure Type when it is connected in line with the stipulations in this
document to a suitable support arm system or pedestal system which also fulfils the
required degree of protection or Enclosure Type.
Operation of the device is only permitted when the device is secured to a suitable support
arm system or pedestal system in line with the stipulations in these operating instructions.
All connection cables of the HMI panel must be routed through the support arm or pedestal.
If the device is extended by optional system components, then the system components
must also meet the required degree of protection or enclosure type. Observe the technical
specifications of the system components.
ESD
An electrostatically sensitive device is equipped with electronic components. Due to their
design, electronic components are sensitive to overvoltage and thus to the discharge of static
electricity. Note the corresponding regulations when handling ESD.
Industrial Security
Siemens provides products and solutions with industrial security functions that support the
secure operation of plants, systems, machines and networks.
In order to protect plants, systems, machines and networks against cyber threats, it is
necessary to implement – and continuously maintain – a holistic, state-of-the-art industrial
security concept. Siemens’ products and solutions constitute one element of such a concept.
Customers are responsible for preventing unauthorized access to their plants, systems,
machines and networks. Such systems, machines and components should only be connected
to an enterprise network or the internet if and to the extent such a connection is necessary
and only when appropriate security measures (e.g. firewalls and/or network segmentation)
are in place.
For additional information on industrial security measures that may be implemented, please
visit (https://www.siemens.com/industrialsecurity).
Siemens’ products and solutions undergo continuous development to make them more
secure. Siemens strongly recommends that product updates are applied as soon as they are
available and that the latest product versions are used. Use of product versions that are no
longer supported, and failure to apply latest updates may increase customer’s exposure to
cyber threats.
To stay informed about product updates, subscribe to the Siemens Industrial Security RSS
Feed under (https://www.siemens.com/cert).
To Next Page
Loading...
