ITC V3, ITC V3 PRO
Operating Instructions, 03/2024, A5E42761061-AF
41
Installing and connecting the device
3.1 Preparing for installation
Points to observe when selecting the mounting location:
• Position the HMI device so that it is not subjected to direct sunlight.
• Position the HMI device such that it is ergonomically accessible for the operator.
Choose a suitable mounting height.
• Note the permissible mounting positions.
3.1.1 Checking delivery
Check the package content for visible signs of transport damage and for completeness.
A damaged part will cause the HMI device to malfunction.
Do not install parts damaged during shipment. In the case of damaged parts, contact your
Siemens representative.
Check the scope of supply of the HMI device (see Product package (Page 16)).
Additional documents may be included in the delivery.
The documentation is part of the HMI device and is required for subsequent commissioning.
Keep all enclosed documentation for the entire service life of the HMI device. You must pass
along the enclosed documentation to any subsequent owner or user of the HMI device. Make
sure that every supplement to the documentation that you receive is stored together with the
operating instructions.
To Next Page
Loading...
