Siemens SIMATIC ITC1200 V3 - Setting up Startup Connection; PROFINET Basic Functions

ITC Operating mode
5.5 Assigning device parameters
ITC V3, ITC V3 PRO
Operating Instructions, 03/2024, A5E42761061-AF
101
• When "Encryption" is enabled (Sm@rt connection only), the data is transferred encrypted
between client and server. In this case, activate encryption on the server as well.
If the server does not support this function, an error message will be displayed. Depending
on the height-to-width ratio, the server screen is displayed within a black bar.
• When "Multitouch" is enabled, you can use a server with a multitouch-capable operating
system in multitouch mode.
Note
Server operating system with multitouch support required.
When you enable the "Multitouch" setting for the connection to a server with a
non-
multitouch
-capable operating system, it is not possible to operate the server via the
Industrial Thin Client. Only enable the "Multitouch" setting for the connection to a server
with a multitouch
-capable operating system.
5.5.7.3 Setting up startup connection
Introduction
You can designate each client-server connection as an autostart connection. This means that
this client-server connection will also be started every time the device starts. The autostart
connections can be restarted even after the configuration settings have been changed.
Note
Limited number of client
-server connections
A maximum of 5 client
-server connections can be started at the same time. If a 6th
connection is activated, an error message appears
The order cannot be defined for startup. Therefore, which of the autostart connections will
ultimately be displayed on the screen is undefined. However, you can generally switch
between the client-server connections.
Procedure
Proceed as follows to identify a client-server connection as an autostart connection:
1. Choose "Configuration > Connections" in the Start menu.
2. Select a client-server connection.
3. Touch the "Edit" button to confirm.
4. Select the "Autostart connection" option.
5.5.7.4 PROFINET basic functions
Introduction
The PROFINET basic functions help to diagnose the device using standard mechanisms. The
required diagnostics functions are available, for example, in STEP 7.