Siemens SIMATIC ITC1200 V3 - Assigning Device Parameters; Possible Applications; Opening the Configuration

ITC Operating mode
5.5 Assigning device parameters
ITC V3, ITC V3 PRO
Operating Instructions, 03/2024, A5E42761061-AF
83
5.5 Assigning device parameters
5.5.1 Possible applications
The Industrial Thin Client can fulfill the following functions as an operator terminal:
• Access to an HMI device as a Sm@rtServer client via the WinCC Sm@rtServer option.
• Access as a client via the "RDP" protocol.
• Access as a client via the "VNC" protocol.
• Access a Citrix server as Citrix client.
• Access as a client on a WinCC OA server.
• Access as a web client to a web server, e.g. of an S7 controller or the Intranet.
When the device accesses a server, for example, an HMI device or a PC, as a client, the screen
display of the server is shown on the screen of the Industrial Thin Client. The user uses the
Industrial Thin Client to access programs or projects on the server.
Note
"Sm@rtServer", "RDP", "VNC", and "Web" are referred to as connection types in this document.
Note
The web browser of the Industrial Thin Client up to and including firmware version V3.2.0.0
is based on Firefox version ESR
52.
With firmware version V3.2.1.0, the Firefox
-based web browser of the Industrial Thin Client
was replaced by a Chromium
-based browser. This web browser is based on Chromium
Version 89.
5.5.2 Opening the configuration
This section describes how you can make configuration settings on the device.
Note
Alternatively, you can edit the configuration settings of the device via remote access from a
PC, see section "Remote configuration (Page 110)".
Procedure
1. In the Start menu, press the "Start menu" icon.