ITC V3, ITC V3 PRO
Operating Instructions, 03/2024, A5E42761061-AF
35
Safety instructions
2.1 General safety instructions
The device is designed for use in the industrial sector for operating and monitoring plant
processes.
Observe the safety and accident prevention instructions applicable to your application in
addition to the safety information given in the device documentation.
Safety of the plant or system
The planner is responsible for the safety.
The safety of the plant or system into which the device is integrated is the responsibility of
the plant or system planner.
Safety instructions for built-in units
The rear of the device constitutes open equipment.
The rear of the device constitutes open equipment. This means that the device may only be
installed in an enclosure or cabinet which provides front access for operating the device.
The enclosure or the cabinet must provide protection against electric shock and the spread
of fire. The enclosure or the cabinet must meet the requirements for mechanical strength
and the degree of protection for the relevant application.
Access to the enclosure or cabinet in which the device is installed should only be possible by
means of a key or tool and for trained and authorized personnel.
Electrocution risk when control cabinet is open
When you open the control cabinet, there may be a dangerous voltage at certain areas or
components.
If you touch these areas or components, you may be killed by electric shock.
Disconnect the cabinet from the mains before opening it. Do not plug in or pull out the
system component during operation.
To Next Page
Loading...
