Siemens SIMATIC ITC1200 V3 - Using a USB Reader

ITC Operating mode
5.7 Operating ITC
ITC V3, ITC V3 PRO
126 Operating Instructions, 03/2024, A5E42761061-AF
5.7.5 Using a USB reader
The following USB readers will be supported for connection type "RDP" from firmware version
V3.2.2.0 onwards.
Note
Connect the USB readers to the Industrial Thin Client before establishing the RDP connection.
Otherwise, the RDP connection must be closed and re-established.
• SIMATIC MV32x optical handheld reader
• SIMATIC RF10xxR readers, which can be used, for example, in connection with the
software PM-LOGON or SIMATIC Logon
With Windows systems, proceed as follows to use the RFID readers:
1. Log on to the device as an administrator.
2. Open "gpedit.msc" via the Windows icon, the Windows search or via the command prompt.
3. Select "Computer configuration > Administrative Templates > Windows Components >
Remote Desktop Services > Remote Desktop Session Host > Device and Resource
Redirection"
4. Double-click the "Do not allow supported Plug and Play device redirection" setting.
5. Select "Disabled".
6. Save the setting with "OK".
See also
Connecting a USB device (Page 65)