ITC Operating mode
5.5 Assigning device parameters
ITC V3, ITC V3 PRO
Operating Instructions, 03/2024, A5E42761061-AF
89
Example: If you touch the "Workstation" icon in Windows for more than 2 seconds, the
operating system or application will respond as though you had right-clicked the icon: the
context menu is displayed where you can select the "Properties" item, for example.
Update firmware
You update the device firmware either directly on the device via USB or with remote access
from a PC, see section "Remote configuration (Page 110)".
Data loss during firmware update
All configuration settings are lost during a firmware update. The factory settings are
restored after the update, which also resets passwords.
Back up the configuration file beforehand and reload it afterward (see below).
Damage to the device
If the power supply or the connection to the device containing the firmware is interrupted
during the update process, the device may no longer be functional.
• Ensure that the power supply and the connection to the device are maintained during
the entire updating process.
• Make sure that all applications running on the device are closed.
• Before updating the firmware, restart the device to prevent memory problems.
In the "Device configuration" area, use the "Update" button to select an update file "*.upd".
The selected file will be transferred to the device. To determine whether the selected file is
suitable for the device, the system checks it against the following criteria, for example:
• The selected file is an update file.
• The selected update file is more current than the version installed on the device.
• The selected update file is suitable for this device.
If all the criteria are met, the selected update file will be run on the device. The device and
the Setup Wizard restart automatically.
The progress of the update is displayed on the screen.
To Next Page
Loading...
