Siemens SIMATIC ITC1200 V3 - Installing a Strain Relief

Installing and connecting the device
3.1 Preparing for installation
ITC V3, ITC V3 PRO
Operating Instructions, 03/2024, A5E42761061-AF
45
3.1.3.4 Installing a strain relief
Requirement
For the assembly of the strain relief bracket you require:
• The strain relief bracket from the scope of delivery
• A torque screwdriver with a T20 bit
Procedure
Fasten the strain-relief with the screws intended for this purpose, torque 0.8 Nm.
The screws are already inserted in the device in the delivery state.
The figure below shows an example.