Siemens SIMATIC ITC1200 V3 - Networks Without Connection to the Company Network

SINUMERIK operating mode
6.2 Networking
ITC V3, ITC V3 PRO
Operating Instructions, 03/2024, A5E42761061-AF
141
6.2.3.2 Networks without connection to the company network
Configuration 1: NCU and ITC
An ITC is connected directly via Ethernet to X120 on the NCU. NCU and ITC are suitably
preconfigured with IP addresses.
The IP addresses are not significant for further operation.
The direct connection of the NCU via X120 to the ITC automatically establishes a simple
system network consisting of two computer nodes.