Siemens SINAMICS SIMOTICS S200 PROFINET - Safety Labels on the Motor

5.2.3 Safety labels on the motor
Description
NO
TICE
Damage to the encoder due to shocks
Shocks at t
he motor shaft extension can cause an encoder damage.
• Do not exert any shock at the shaft extension.
In the delivery state, the following two warning labels are attached to the motor. In addition,
there ar
e three "hot surface" warning labels included in the scope of delivery. Before
mounting the motor, attach them to the motor surfaces and make sure that they are clearly
visible on all the four longitudinal sides of the motor.
"Hot surface" warning label
"No shocks at the shaft extension" warning label
Mounting
5.2Motor
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB 107