Siemens SINAMICS SIMOTICS S200 PROFINET - Terminating the Online Connection from the Converter

8.8.4 Terminating the online connection from the converter
Overvie
w
After you traverse your converter from the control panel or optimize the axis, you need to
disconnect the online connection to the converter.
Requirement
• For activated user management (UMAC):
The function rights required to edit the converter data are activated for your user account.
Details on this topic are provided in Chapter "Security settings in Startdrive" of Industrial
Cybersecurity Con󹪝guration Manual (
https://support.industry.siemens.com/cs/ww/en/view/
109810578).
Procedure
Pr
oceed as follows to
1. Click the drive in the project tree.
2. Click
in the menu bar.
Result
The online connection to t
he converter is disconnected.
Commissioning (Startdrive)
8.8Optimizing commissioning
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB 293