Siemens SINAMICS SIMOTICS S200 PROFINET - Loading Data from the Drive into the Project

8.3.4 Loading data from the drive into the project
Overvie
w
If you change the con󹪝guration of a converter in the online mode, then the con󹪝guration
deviates from the data in the Startdrive project. To update project data, load the drive data from
the converter into the project.
Requirement
• A project with a matching drive is created and is open in Startdrive.
• The converter and SIMATIC S7 controller are in o󹪠ine mode.
• For activated user management (UMAC):
The function rights for editing drive data are activated for your user account.
Details on this topic are provided in Chapter "Security settings in Startdrive" of Industrial
Cybersecurity Con󹪝guration Manual (
https://support.industry.siemens.com/cs/ww/en/view/
109810578).
Commissioning (Startdrive)
8.3Basics
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
224 Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB