Siemens SINAMICS SIMOTICS S200 PROFINET - Series Commissioning with SD Card

9.1 Series commissioning with SD card
Requir
ement
• The machines that are commissioned via series commissioning are identical in terms of the
application, converter and motor.
Procedure
Proceed as follows to perform series commissioning using an SD card:
1. Insert an empty SD card with a maximum capacity of 32 GB (e.g.: 6SL5570-0GC00-0AA0)
into the card slot of the converter while it is switched o󹪜.
2. Switch on the converter and perform commissioning.
3. Save the settings at the end of commissioning.
This saves the settings in a non-volatile manner not only on the converter but also to the SD
card.
4. Switch o󹪜 the converter and remove the SD card from the converter.
5. Insert the SD card into the next, and switched o󹪜 converter.
6. Switch on the converter and wait until it has ramped up - the RDY LED lights green.
During ramp-up, the converter takes the settings from the SD card - including user
management and access control.
7. Switch o󹪜 the converter and remove the SD card from the converter.
Repeat steps 5to7 for all converters to which you want to transfer these settings.
Series commissioning
9.1Series commissioning with SD card
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
316 Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB