Siemens SINAMICS SIMOTICS S200 PROFINET - Networking a Controller and a Converter

5. Assign a di󹪜erent device name in "①" if r
equired.
6. Click "OK".
If "③" is activated, the SIMATIC S7 controller is automatically created in the project and then
displayed in the device view.
Result
The inserted SIMATICS7 controller is displayed in the device view and can be con󹪝gured.
8.5.2.2 Networking a controller and a converter
Overview
After inserting a SIMATIC S7 controller and a converter into the project, network the components
in the network and topology view.
Requirement
• A project is open.
• The project includes at least one drive and one control system.
• For activated user management (UMAC):
The function rights for editing drive and control system data are activated for your user
account.
Details on this topic are provided in Chapter "Security settings in Startdrive" of Industrial
Cybersecurity Con󹪝guration Manual (
https://support.industry.siemens.com/cs/ww/en/view/
109810578).
Commissioning (Startdrive)
8.5Combining and con󹪝guring devices in t
he project
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB 245