Siemens SINAMICS SIMOTICS S200 PROFINET - Alarms; Explanation of the List of Faults and Alarms

12.3.3 Alarms
Overvie
w
An alarm indicates that the reliable operation of the motor by the converter is at risk.
Description of function
Properties of alarms
Alarms have the following properties:
• Incoming alarms have no direct in󹪞uence on the drive system.
• When the cause is eliminated, the alarm is no longer displayed.
• Alarms do not have to be acknowledged.
• Alarms are displayed as follows:
– On the converter via the LEDs
– On the SINAMICS SDI Status panel via the 6-digit 7-segment display
– In the web server
You can 󹪝nd more information on the display of alarms in Section "Messages".
– In Startdrive
You can 󹪝nd more information on the display of alarms in Section "Display messages
(Page294)".
Alarm code or alarm value describe the cause of the alarm.
More information
You can 󹪝nd more information on alarms in Section "Overview of faults and alarms (Page 428)".
12.3.4 Explanation of the list of faults and alarms
Overview
The representation of a message includes as a maximum the information listed below.
Depending on the message, some information can be omitted.
The messages are displayed according to the following pattern:
System messages
12.3Faults and alarms
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
430 Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB