You may only use the products when the following requirements are complied with:
• All regulations and dir
ectives that are applicable at the place of nal use, especially with
regard to electrical safety, functional safety and electromagnetic compatibility (EMC).
• All instructions, notes, technical data, safety information and cybersecurity information
contained in this document and other supporting documentation.
The products are part of a machine or system. When designing the system, apply suitable
measures to ensure that the products can provide intended safety to persons and material
assets and achieve intended electromagnetic compatibility.
Perform a risk assessment of the complete application, including third-party products and
implement adequate safety and cybersecurity measures before using the product.
Products without protective enclosure (IP00 or IP20) are intended for installation in control
panels or control cabinets that provide the required level of protection.
Any other use that is not expressly permitted can result in malfunctions and unpredictable
hazards.
The motors are intended for converter control and may not be connected directly to the line
supply. The motors are not approved for use in explosive atmospheres.
1.5.2 Firmware updates and constraints
Description
Firmware updates and constraints for the converters with the current rmware are available in
SIOS:
Updates and constraints for SINAMICS S200 (
https://support.industry.siemens.com/cs/ww/en/
view/109812409)
1.5.3 Open-source sof
tware (OSS)
Description
The license conditions and copyright information of the open-source software components
used by the device are saved on the device itself. You can download license and copyright
information onto your PC via the support page of the integrated web server.
Introduction
1.5Important product information
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
22 Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB
To Next Page
Loading...
Need help?
General
