Siemens SINAMICS SIMOTICS S200 PROFINET - Page 133

Connection type Terminal type Conductor cross‑section Stripping length Cable lug
STO connection
2)
Spring-loaded 0.2mm² ... 1.5mm²
(A
WG: 24 … 16)
10mm Pin-type
Motor power connec‐
tion
Spring-loaded 0.75mm² ... 2.5mm²
(AWG: 18 …12)
9mm ... 10mm
Pin-type
Motor holding brake
2)
Spring-loaded 0.38mm² ... 0.75mm²
(AWG: 22 … 18)
9mm ... 10mm
Pin-type
1)
If you use cable lugs with insulat
ed end sleeves, make sure that the length of the cable lugs is 12 mm.
2)
For S200 PN only
More information
For more information about assembling cable terminals, see Section "Assembling cables
(Page879)".
Connecting
6.3Cables and connectors
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB 131