Requirement
To reduce the stress on the mechanical system, the torque limit can be reduced before OBT. After
OBT has been completed, the previous value can be set again.
NOTICE
Material damage caused by an impermissible direction of motion of the motor
One Button
Tuning runs the motor in both directions. Impermissible directions of motion can
damage the machine or installation.
• If a particular direction of motion of the motor is impermissible, do not carry out One Button
Tuning.
Commissioning (web server)
7.4Functions and menus
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
184 Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB
To Next Page
Loading...
