Siemens SINAMICS SIMOTICS S200 PROFINET User Manual

• Language setting
• Date and time
In t
he following cases it may be necessary to restore the converter to factory settings:
• Incomplete commissioning
• If the motor is changed
• If there is uncertainty regarding the previous parameterization and/or the previous use of the
converter
Requirement
• There is an online connection between the project and the drive (see Chapter "Establishing
an online connection to the converter (Page288)").
• For activated user management (UMAC):
The function rights required for "Restore factory settings" are activated for your user account.
Details on this topic are provided in Chapter "Security settings in Startdrive" of Industrial
Cybersecurity Con󹪝guration Manual (
https://support.industry.siemens.com/cs/ww/en/view/
109810578).
Procedure
Pr
oceed as follows to restore factory settings:
1. In the secondary navigation, click on menu "Backup/Restore".
The corresponding function view opens.
2. Click the "Start" button in the "Restore factory setting" 󹪝eld.
Result
The converter is reset and then restarted. If the "RDY" and "COM" LEDs on the converter light up
green, resetting is complete.
More information
For a full reset of the converter, see Section "Reset of all user-de󹪝ned settings to the factory
setting via an SD card (Page587)"
Commissioning (Startdrive)
8.9Using online diagnostic functions
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB 307

Siemens SINAMICS SIMOTICS S200 PROFINET Specifications

General

Brand	Siemens
Model	SINAMICS SIMOTICS S200 PROFINET
Category	Servo Drives
Language	English