Siemens SINAMICS SIMOTICS S200 PROFINET - Page 34

WARNING
Fire due to incorrect operation of the motor
When incorrectl
y operated and in the case of a fault, the motor can overheat resulting in 󹪝re
and smoke. This can result in severe injury or death. Further, excessively high temperatures
destroy motor components and result in increased failures as well as shorter service lives of
motors.
• Operate the motor according to the relevant speci󹪝cations.
• Only operate the motors in conjunction with e󹪜ective temperature monitoring.
• Immediately switch o󹪜 the motor if excessively high temperatures occur.
CAUTION
Burns and thermal damage caused by hot surfaces
T
emper
atures above 100 °C may occur on the surfaces of motors, converters, and other drive
components.
Touching hot surfaces may result in burns. Hot surfaces may damage or destroy temperature
sensitive parts.
• Ensure that temperature-sensitive parts do not come into contact with hot surfaces.
• Mount drive components so that they are not accessible during operation.
Measures when maintenance is required:
• Allow drive components to cool o󹪜 before starting any work.
• Use appropriate personnel protection equipment, e.g. gloves.
Fundamental safety instructions
2.1General safety instructions
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
32 Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB