Siemens SINAMICS SIMOTICS S200 PROFINET - Page 606

Replacing the motor with a motor with another article number
If you are using a
di󹪜erent motor type, after performing the three steps above, you must also
carry out the following steps:
1. Reset the converter to factory settings.
You can 󹪝nd more information in Section "Restoring the converter to factory settings
(Page587)".
2. Commission the converter. You can 󹪝nd more information in the following sections:
"Commissioning (web server) (Page163)"
"Commissioning (Startdrive) (Page219)"
"Series commissioning (Page315)"
Result
You have now replaced the motor.
Corrective maintenance
13.2Service and maintenance for the motor
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
604 Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB