Siemens SINAMICS SIMOTICS S200 PROFINET User Manual

Table 14-14 Environmental conditions during operation
Environmental conditions during operation according to 3K4 to DINENIEC60721‑3‑3, except for environmental vari‐
ables "lo
w air tem
perature", "condensation" and "low air pressure"
Installation altitude Up to 1000 m above sea level without limitations
You can ge
t additional information in Section "Derating factors
(Page627)".
Climatic environmental conditions
1)
• Temperature: -15 °C ... +40 °C, power derating at higher temperatures
• Relative humidity
: < 90% at 30 °C, condensation not permissible
• Absolute air humidity: 1g/m³ ... 29 g/m³
• Rate of temperature change
2)
: 0.5°/min
• Atmospheric pressure: 89kPa
1) 3)
... 106 kPa
4)
• Solar radiation: 700 W/m²
2)
• Movement of the air: 1.0 m/s
• Water (other than rain): see Section "Degree of protection (Page629)"
Mechanical environmental conditions
• Vibration severity grade: A (according to IEC60034‑14:2003)
• Shock r
esistance (m/s
2
):
– 1FL2102, 1FL2☐03, 1FL2104, 1FL2204, 1FL2☐05: 50 (continuous
in axial direction), 50 (continuous in radial direction), 300 (in a short
time of 11 ms)
– 1FL23☐☐: 25 (continuous in axial direction), 50 (continuous in ra‐
dial direction), 300 (in a short time of 11 ms)
Protection against chemical substances Protected according to 3C2 to DIN EN IEC 60721‑3‑3
Biological environmental conditions Suitable according to 3B2 to DIN EN IEC 60721‑3‑3
Pollution Suitable for environments with degree of pollution 2 according to
IEC61800‑5‑1
Cooling air Clean and dry air
The motors are not suitable for operation under the following circumstances:
• In a v
acuum
5)
• In salt-laden or aggr
essive atmospheres
• Outdoors
1)
Increased ruggednes
s with regard to low air temperature and low atmospheric pressure better than 3K3 according to
DINENIEC60721‑3‑3
2)
Averaged over a period of 5min
3)
The limit value of 89kPa covers applications at altitudes up to 1000m.
4)
Conditions in mines are not considered.
5)
Operation in a vacuum is not permissible because of the low dielectric strength and poor heat dissipation.
Technical data
14.2Technical data of the motor
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB 625

Siemens SINAMICS SIMOTICS S200 PROFINET Specifications

General

Brand	Siemens
Model	SINAMICS SIMOTICS S200 PROFINET
Category	Servo Drives
Language	English