CD600 Plus - User’s Manual
7.4
Serial Communication Network
The interface ICS2.0P replaced converting the old interface ICS2.0-1 and converts the RS232 to
RS485 port of the computer to the network controller. This new converter can be mounted on DIN
rail using only one slot in the rack. The converter has great improvements incorporated.
Radical changes in the controller has not been made because of its design is beyond its time, and
also because the compatibility with the systems installed before an application was very important
for their development. CD600 Plus is compatible with the existing engineering tools, drivers, and the
HMI system Smarcom. The configurator software for the portable terminal and are able to configure
the CD600.
Ethernet communication Network
The ENET-710 interface converts RS485 to Ethernet network controllers. For more details, see the
manual of the ENET-710.
To Next Page
Loading...