CONF600 PLUS – User’s Manual
12.2
Main toolbar
To activate the Main toolbar, go to the View menu and click the option Toolbar. The Main toolbar is
displayed on the working area by default.
Figure 12.4 - Main Toolbar
The table below describes the buttons functionality:
Creates a new project.
Open an existing project file.
Save the project file.
Prints the configuration project.
Opens the Print Preview window.
Remove the selection and copy it to the Clipboard.
Copy the selection to the Clipboard.
Paste the contents from the Clipboard into the drawing area.
Undo changes up to the last save. To undo two or more actions at a time, click the
down arrow then select the actions to be undone.
Redo the action executed by the undo command up to the last save. To redo two or
more actions at a time, click the down arrow then select the actions to be redone.
Displays the entire loop page on the screen.
Displays the loop page width on the screen.
Displays half of the loop page width on the screen.
Shows/Hides the Block List.
Opens the Online dialog box.
Opens the Online help application.
Drawing toolbar
To activate the Drawing toolbar, go to the View menu, select Tool Boxes and click the option
Drawing. The Drawing toolbar is displayed on the working area by default.
Figure 12.5 - Drawing Toolbar
These options are also available from the Tool menu > Draw Tools.
The table below describes the buttons functionality:
To Next Page
Loading...
Need help?
General