SMAR CD600 Plus - Creating a New Configuration Project; Building Strategy: Adding Blocks

Conf 600 – User’s Manual
18.2
Starting the Configurator
To start CONF600 Plus, select the Start menu > Programs > Smar > CONF600 Plus > CONF600
Plus.
Figure 18.3 - Starting the CONF600 Plus
Creating a New Configuration
Click the New button,
, on the main toolbar. A new project window will open. There are 5 tabs at
the bottom of the page representing the loops:
Figure 18.4 - Loop Tabs
To name the configuration project, right-click on the Loop G tab. The Loop Name dialog box will
open. Type the name "Sample" in the text box (the name is limited to 8 characters). It means that
the configuration project will be saved with this name. Click Ok to conclude this task.
Figure 18.5 - Loop Name Dialog Box
Building the Strategy
Adding blocks
1. Right-click the Loop 1 tab and type the name "Mix A.B" at the Loop Name dialog box. Click Ok to
return to the working area.
2. Select the Node tool,
, on the Drawing toolbar.
3. Move the cursor onto the working area. The mouse cursor will turn into a circle. Click the
drawing area to place a new Function Block and the Block dialog box will open.